SRP2 ClutchMOZA SRP2 Clutch Pedal — the third pedal for an SRP2 set: height, angle and preload adjustment

Standing starts and heel-and-toe, done properly

The MOZA SRP2 Clutch Pedal turns a two-pedal SRP2 set into a full three-pedal set. It bolts straight onto the SRP2 base next to the throttle and brake and uses the same enclosed mechanism with a polished steel shaft as the rest of the series. Once fitted, the pedal is tuned to your seating position: face height, face angle and the two-step spring preload all adjust, which sets both the effort and the bite point. A light, predictable action matters wherever the clutch is in constant use — standing starts, heel-and-toe downshifts, and manual shifting with the clutch in drift and rally. This is an accessory rather than a standalone device: it only works as part of an SRP2 pedal set and connects to its base. MOZA states explicitly that the SRP2 clutch is not compatible with the SRP Lite2 pedals from the R5 Pro set, nor with the R3 and R5 series. A tool kit for installation is included.

1. 01

   The third pedal, where it is needed

   A basic SRP2 set is throttle and brake. Not everyone needs a clutch, but standing starts, heel-and-toe downshifts and manual shifting with the clutch all depend on one. This pedal adds the third axis to a set you already own, without changing the base or buying the whole set again.

2. 02

   It adapts to your foot, not the other way round

   The face adjusts for height and angle, so the clutch can sit level with the throttle and brake or a little higher, whichever suits how you sit. Spring preload switches between two steps: softer for relaxed traffic driving in sims, firmer for race cars where the clutch is kicked hard and short.

3. 03

   The same mechanism as the rest of the set

   The clutch is built on the same enclosed spring mechanism with a polished steel shaft as the SRP2 throttle and brake: the travel is smooth and quiet, and soft cushioning kills the knock at the end stops. It looks identical to its neighbours too — the same perforated face and the same black finish.

4. 04

   Check that your pedals really are SRP2

   This is the most common cause of disappointment, and MOZA says so on the product page itself: the clutch fits SRP2 series pedals only. It does not fit the SRP Lite2 supplied with the R5 Pro set, and it is not intended for the R3 and R5 sets. If you are unsure which series you own, tell the GEEKSHOP manager your base and pedal model before placing the preorder.